If the turn signal fails within a few weeks, replace the socket or the turn signal assembly if necessary. If this is your problem, try using sandpaper to clean the socket and try reinstalling it. The socket contact points heat up to the point where they start to melt.
We have seen cases where the turn signal stopped working due to inadequate electrical contact between the turn signal bulb socket and the headlamp housing. Clean it electrical contact cleaner if necessary. Remove the electrical plug from the turn signal unit that is not working and inspect it. The electrical plug that plugs into the headlight or taillight assembly may be loose or not making good contact. Replace the light bulb with a new bulb that has the recommended wattage and bulb type.
#1998 mercedes kompressor tail light assembly manual
Look in the owner’s manual to find the location of the fuse panels for your Mercedes.Ģ. Check the turn signal fuses in your fuse panel under the dash and engine compartment. Nonetheless I believe it should be noted.1. I suspect that failures in other vehicles were covered by warranty and thus not reported. I believe that this condition is a fire hazard and should be corrected. I will call the dealership on Monday and hope to have the parts returned to me. However when I called the dealership on Saturday the 21st the parts were not there.
He told me he would leave them with the sales department so that I could pick them up that weekend. I requested the old parts and was assured by mr. He told me that no recall had been issued. I asked him if a recall had been initiated because it seemed to me that this was a condition that could cause a fire in the rear of the vehicle, near the gas tank. He told me that they had seen this same problem on other mercedes vehicles. I spoke with the service advisor, alex garcia. The service invoice states "28636 bulb failure mil 852 inspected bulb found evidence of arching between socket and assembly 852 r/r both tail lamp assemblys/82-2310. Both tail lamp assemblies had to be replaced at a cost of $360. The service department inspected the vehicle and told us that the tail lamp bulbs in both tail lamps were arching and had melted the tail lamp assembly. The service was performed on August 16th 2004. When it finally did, a couple of months later, we took the vehicle in to the dealer. We called the dealer, mercedes-benz of wilsonville, (wilsonville oregon - 50) and were told to bring the vehicle in when the warning lamp came on and stayed on. It would not stay on all the time however, and we could not find which lamp was malfunctioning.
The light, that warns of a lamp failure somewhere on the vehicle, kept coming on.
0 kommentar(er)
